Products

This rocket fin and nose cone set are compatible with either TU2005 OR TU2007 1oz. rocket tubes. The fin can is a snug fit, however, variances in p...

Here are several different style nose cones meant to replace the lid of a 35mm film canister. Specifically the style of 35mm film canisters commonl...

This design is a payload cup for 3"+ shells for 37mm flare launchers. 1.35" OD For 3"+ Shell WARNING! These models are likely not suitable for re...

This design is a payload cup for 3"+ shells for 37mm flare launchers. 37mm Payload Cup - 1.350"OD x 1" ID For 3" Shell Flare WARNING! These model...

37mm Payload Cups - Multiple Configurations - 1.295" OD / 1" ID   WARNING! These models are likely not suitable for real-world use out of the bo...

37mm Powder Bushing / Cup 40 Grain Capacity For Reloadable Shells For Flare Launcher Use WARNING! These models are not suitable for real-world use...

37mm 2", 3", & 5" Shell Casings Model For Flare Launcher WARNING! These models are not suitable for real-world use out of the box as a 3D-pri...

Fin set fits many fireworks bottle rocket brands.   Designed By: rebeltaz

Nose cone fits many fireworks bottle rocket brands.   Designed By: rebeltaz

Fuse plug for converting the TU2032 (.780" ID x 2" Length) into a small shell suitable for backyard displays. The fuse hole is compatible with 2-3m...

The rocket is designed to use Estes motors which are either 18mm or 24mm in diameter (B, C, D series motors). You can buy rocket motors on the inte...

The TU1375 (1" ID x 6" Length) makes a great small mortar tube along with this base and is suitable for launching small shells made from the TU2032...

Fuse plug for converting the TU2032 (.780" ID x 2" Length) into a small shell suitable for backyard displays. The fuse cavity can be packed with st...

Concept for Round shell casing filled with exploding stuff. . Great for smoke bombs and ground effects if printed using PLA. For an aerial shell pr...

Solid plug for converting the TU2032 (.780" ID x 2" Length) into a small shell suitable for backyard displays. The plug is a tight fit and can be u...

The 3D Printed Mini Shells Supplies Kit contains all of the supplies you need to assemble 100 mini-shells and 5 mini-mortars, plus it contains an a...

This wonderful Stinger Missile REFILL Kit is easy to make and it's hefty size will satisfy the need to shoot missiles in the air and put a smile on...

This spectacular Stinger Missile Kit is easy to make and it's hefty size will satisfy the need to shoot missiles in the air and put a smile on your...

Effect fuses, such as this Willow Diadem Fuse are used in contracting fireworks shells and rocket headings. The fuse is cut into 1/2"-1" lengths an...

4" ID x 15 inches long with wooden plug in bottom. These HDPE Mortar Tubes are Black or Orange depending on current availability. IMPORTANT: Firin...

4 inch ID x 22 inches long, approx. 1/5" wall, with fiberglass resin plug in the bottom and structurally reinforced lip to prevent fraying. Weighs ...

4-inch paper fireworks shell hemispheres. These paper hemispheres come in sets of 2 halves. They're approximately 3-5/8" in diameter before pasting...

3-11/16" spherical plastic fireworks shells, 4" in a diameter when pasted and fused. Comes in two halves, one with a 7/32" time fuse hole, one with...

4-ounce rocket tubes were specially made so that plastic ball shell #PL2020 will fit on top of them. These parallel wound tubes can also be used to...